For best results, shampoo and towel dry your hair or use on clean, dry hair.
Check the voltage is correct before plugging the brush into the mains socket.
Plug in the ceramic brush, the LCD panel will display ‘OFF’.
Press the Start/Stop button for 2 second to turn the brush on.
The LCD panel will briefly display the lowest temperature (180°F/80°C), the brush will automatically start to heat up, after approximately 2 minutes the temperature will be reached (385°F/200°C).
To adjust the temperature, simply press the ‘+’ to increase the temperature or (-) to reduce the temperature by 20°F/10°C.
The set temperature on the display will flash and then gradually increase or decrease on the LCD panel until it reaches your preferred temperature. Maximum temperature is 385°F/200°C.
To change from °C to °F or °F to °C, press the ‘+’ and ‘-’ buttons simultaneously for 2 seconds to make the change.
Brush or comb hair through to remove any tangles.
For best results, separate the hair into sections and start with the layers underneath.
Hold the hair taught and slowly pass the brush along the section of hair, different hair textures will require the brush to pass through several times.
After use, for safety press the Start/Stop button again for 2 seconds to turn the device off.
Unplug from the wall socket , do not pull the cord, firmly grip the plug and remove from the socket.
